首页 > 资源导航 > 标准 > 车辆 > 车辆综合
标准分类
发布日期
全部
订阅
收起
标准
  • ISO 3888-2-2002 - 中外标准 - - 2002/11 - 作废
    ISO 3888-2:2002 defines the dimensions of the test track for a closed-loop, severe lane-change manoeuvre test for subjectively determining the obstacle avoidance performance of a vehicle: one specific part of vehicle dynamics and road-holding ability. It is applicable to passenger cars as defined in ISO 3833 and light commercial vehicles up to a gross vehicle mass of 3,5 tonnes.
  • ISO/TS 20119-2002 - 中外标准 - - 2002/11 - 废止
    ISO/TS 20119:2002 specifies a test schedule that addresses certain aspects of the on-centre handling characteristics of a vehicle, on-centre handling being used to describe the steering "feel" and precision of the vehicle during nominally straight-line driving and in negotiating large-radius bends at high speeds but low lateral accelerations. It is applicable to passenger cars in accordance with ISO 3833, and to light trucks.
    转向机构轮胎试验车行道(公路)方向盘驱动类型道路车辆方位稳定性转向轮胎直线机构摩托车driving stylescarriagewaysdirectional stabilitysteering wheel tyresstraight-line mechanismmotor vehiclesroad vehicleswindssteering geartestingsteering wheelstyres
  • ISO 15623-2002 - 中外标准 - - 2002/10 - 作废
    ISO 15623:2002 specifies performance requirements and test procedures for systems capable of warning the driver of short inter-vehicle distance and closing speed which may cause a rear-end collision with other vehicles, including motor cycles, ahead of the subject vehicle while it is operating at ordinary speed. ISO 15623:2002 is applicable to operations on roads with curve radii over 125 m as well as higher radius curves.
    定义交通信息和控制系统警报系统道路车辆试验碰撞报警信号警报装置警告装置私人汽车warning devicestransport information and control systemsroad vehiclesalarm systemsprivate carsalarm signalsalarm devicestestingdefinitionscollisionsdefinition
  • ISO 11748-3-2002 - 中外标准 - - 2002/8 - 现行
    Scope This part of ISO 11748 provides an application example of the guidelines and specifications for technical documentation given in ISO 11748-1 and ISO 11748-2. The example is based on the standard generalized markup language (SGML), which is specified in ISO 8879.
    应用范例文献可靠度数据交换文献工作电子设备试验电性质和电现象SGML 语言道路车辆电气设备定义安全definitionssgmlroad vehiclesreliabilitydocumentsexample for applicationelectronic equipmentelectrical properties and phenomenadefinitiontestssafetyelectrical equipmentdata exchangedocumentations
  • ISO 11096-2002 - 中外标准 - - 2002/7 - 作废
    This International Standard specifies a test method for simulating the lateral impact between the front of a motor vehicle (as defined in ISO 3833) of up to 3,5 tonnes GVM (gross vehicle mass) and an adult pedestrian. The test method addresses the reduction of pedestrian thigh, leg and knee injuries. It is not applicable to testing for, or the evaluation of, injuries to other pedestrian body regions; nor does it directly cover the potential risk of injury to children or human soft tissue. It is not applicable to vehicles with deployable devices designed for activation in the event of impact with a pedestrian. However, research suggests that safety improvements in vehicles derived from such pedestrian impact tests would also be beneficial to motorcyclists and bicyclists.
  • ISO 17288-1-2002 - 中外标准 - - 2002/6 - 作废
    ISO 17288-1 specifies an open-loop test method for determining the free control stability of a passenger car as defined in ISO 3833, by measurement of the transient behaviour following steering release, starting from a steady-state cornering status.
  • ISO 8349-2002 - 中外标准 - - 2002/4 - 现行
    摩擦测试方法测试磨耗层(道路)摩擦力试件车行道(公路)表面精整道路车辆CarriagewaysDefinitionFinishesFrictionFriction forcesRoad vehiclesSurfacesTest methodsTest piecesTestingWearing courses (roads)
  • ISO 11452-5-2002 - 中外标准 - - 2002/4 - 现行
    This part of ISO 11452 specifies stripline tests for determining the immunity of electronic components for passenger cars and commercial vehicles to electrical distrubances from narrowband electromagnetic energy, regardless of the vehicle propulsion system (e.g. spark-ignition engine, diesel engine, electric motor). As the performance of these tests depends on the exposure of the equipment harness to a disturbance field, the applicability of this part of ISO 11452 is limited to equipment harnesses, which have a maximum diameter of one-third the stripline height or less. The electromagnetic disturbances considered are limited to continuous narrowband electromagnetic fields.
    摩托车窄带运载工具元部件电磁兼容性干扰抑制抗扰测试电子设备道路车辆仪器电气试验干扰影响量电缆束带状线电磁干扰辐射测试条件电磁的电缆电子装置Cable harnessesComponentsElectric cablesElectrical testingElectromagneticElectromagnetic compatibilityElectromagnetic interferencesElectronic equipmentElectronically-operated devicesImmunityInfluence quantitiesInstrumentsInterference rejectionsInterferencesMotor vehiclesNarrow bandRadiationRoad vehiclesStriplinesTestingTesting conditionsVehicles
  • ISO 12353-1-2002 - 中外标准 - - 2002/3 - 现行
    This part of ISO 12353 establishes a terminology relating to the investigation and analysis of road traffic accidents and to the application of accident data.
    词汇道路车辆摩托车事故道路运输损坏机构事故后修复交通事故重显道路安全道路事故术语定义Accident reconstructionAccidentsDefinitionDefinitionsInjure mechanismMotor vehiclesRoad accidentsRoad safetyRoad transportRoad vehiclesTerminologyTraffic accident reconstructionVocabulary
  • ISO 22628-2002 - 中外标准 - - 2002/2 - 现行
    This International Standard specifies a method for calculating the recyclability rate and the recoverability rate of a new road vehicle, each expressed as a mass fraction of the vehicle. Under this procedure, performed by the vehicle manufacturer when a new road vehicle is put on the market, potentially, the vehicle can be recycled, reused or both (recyclability rate), or recovered, reused or both (recoverability rate).
    老式车道路车辆计算方法定义抗污染摩托车企业私人汽车再循环利用自加工DefinitionsEnterprisesEnvironmental sustainabilityMethods of calculationMotor vehiclesOld automobilesPrivate carsRecyclingReprocessingRoad vehiclesUtilization
回到顶部
选择了条数据