军事知识服务平台
季节冻土区坡脚嵌固梯形渠道冻胀变形与内力计算
Calculation of frost heave deformation and internal forces in trapezoidal canals with slope toe anchorage in seasonally frozen soil regions
摘要 坡脚嵌固是一种应用广泛的坡脚加固措施,能有效减轻冲刷并增强渠道坡板的稳定性.坡板底端边界条件的改变使此类渠道冻胀特性与三板拼接式渠道不同,但目前缺乏相应的冻胀分析模型.为此,基于弹性冻土地基梁理论建立冻胀条件下坡脚嵌固梯形渠道冻胀力学模型,推导出坡板冻胀变形与内力的解析表达式.分别应用本文模型与有限元模型计算坡板冻胀变形,并与实测值对比,验证了所提方法的适用性.最后,重点分析了地下水埋深对渠道冻胀力学行为的影响规律.结果表明:由于无顶盖板约束,坡顶存在约2.4 mm的抬升位移;坡脚处嵌固体的约束使坡板底端附近变形曲线出现"反弯"区域,与工程实际相符.截面弯矩和剪力均存在正负两个极值点,坡脚及坡板中下部为最易开裂位置.随地下水埋深减小,截面弯矩和剪力最大值(绝对值)均增大.当地下水埋深从3.6 m减小至3.2 m时,坡脚负弯矩极值增大25 kN·m,坡板中下部正弯矩极值增大约7.16 kN·m,坡脚处剪力从136 kN大幅增至211 kN.坡脚处截面弯矩与地下水埋深之间呈线性函数关系,截面剪力与地下水埋深之间呈指数函数关系.本研究可为柔性渠底坡脚加固梯形渠道的防冻胀设计提供参考.
Abstract:
As critical infrastructure in water conveyance and distribution systems,canals play essential roles in irrigation district development,inter-basin water transfer projects,and national water network engineering.However,canal engineering in seasonally frozen soil regions commonly faces severe challenges from frost heave damage.Slope toe anchorage is a widely used slope reinforcement measure that can effectively mitigate scouring effects and enhance the stability of canal slope lining plates.The alteration of boundary conditions at the slope toe results in frost heave characteristics for this type of canal that differ from those of three-plate spliced canals.However,corresponding frost heave analysis models are currently lacking.To address this,a mechanical model for frost heave in trapezoidal canals with slope toe anchorage was established based on the theory of elastic beams on frozen soil foundations,yielding analytical expressions for the frost heave deformation and internal forces of the slope plate.The frost heave deformations of the slope plate were calculated using both the proposed model and a finite element model,and comparisons with measured values demonstrated the applicability of the proposed method.Unlike in three-plate spliced trapezoidal canals,the frost heave deformation curve of the slope plate in a slope toe-anchored canal exhibited an inflection point near the slope toe with zero cross-sectional rota-tion,which was consistent with the deformation characteristics of a fixed end in engineering mechanics.Addi-tionally,under typical working conditions without top cover plate restraint,uplift displacement(2.4 mm)oc-curred at the top of the slope plate,which was consistent with theoretical expectations.This indicated that debonding and void formation were likely to occur near the slope top due to the failure of freezing constraints.In engineering practice,the proposed method can be used to calculate uplift displacement for the preliminary verifi-cation of such frost damage.Finally,the influence of groundwater depth on the frost heave mechanical behavior of the canal was analyzed in detail.The results indicated that as groundwater depth decreased,uplift displace-ment at the top of the slope plate gradually increased.When the groundwater depth decreased from 3.6 m to 3.2 m,the uplift displacement at the slope top increased from 2.4 mm to 3.8 mm.Therefore,a reduction in groundwater depth increased the risk of debonding and void formation between the frozen soil and the lining plate.Furthermore,due to the constraint provided by slope toe anchorage,an inflection region existed in the de-formation curve near the toe of the slope plate,which aligned with engineering practice.Both bending moment and shear force exhibited positive and negative extreme values.The areas near the slope toe and the middle-low-er part of the slope plate were the most susceptible locations for cracking.As groundwater depth decreased,the maximum values(absolute values)of both bending moment and shear force increased.When the groundwater depth decreased from 3.6 m to 3.2 m,the absolute value of the negative bending moment at the slope toe in-creased by approximately 25 kN·m,while the maximum positive bending moment in the middle-lower section of the slope plate increased by about 7.16 kN·m.Bending moments in cross-sections near the slope top remained relatively small and gradually approached zero.The relationship between cross-sectional bending moment and groundwater depth followed a linear function,while the relationship between cross-sectional shear force and groundwater depth followed an exponential function.This study provides a reference for the frost heave resis-tance design of trapezoidal canals with flexible bottom plates and slope toe anchorage.
刊 名 冰川冻土 ISTIC
年,卷(期): 2026, 48(5)
分类号: TV672 TU445
机标分类号: S773.4 TU43 S275
在线出版日期: 2026年11月2日
基金项目: 2023M743746:中国博士后科学基金GZC20232956:国家资助博士后研究人员计划42401174:国家自然科学基金U2003108:国家自然科学基金,