基于等离子体流体模型的氩-汞放电管模拟研究
Fluid-model-based simulation of Ar-Hg plasma tube discharges
摘要
氩-汞(Ar-Hg)气体放电在高效照明、紫外线杀菌等领域具有广泛应用,然而其内部复杂的微观物理过程与放电机理尚未得到完全清晰的阐释.本文将放电管中等离子体流体模型与外电路相耦合,放电管建模为1D 轴向 Ar-Hg 等离子体放电,外电路由交流源驱动,自洽求解了外电路特性与放电管内等离子体轴向电子密度分布、电子温度以及碰撞频率.放电管在放电初期电压不断降低,放电电流小幅提升,稳定后粒子在两电极处较高,轴向上基本相等.放电管在 400 Ω 镇流电阻下电子密度达1.9×1018 m-3,在氩分压57 Torr 下有最大电子密度4.7×1018 m-3,电子温度随氩分压的升高从8 240 K 降低为4 178 K,碰撞频率从0.5 GHz 升高到11.8 GHz,相关结论为后续优化Ar-Hg 气体放电电子密度提供理论工具.
Argon-mercury(Ar-Hg)gas discharge is widely used in high-efficiency lighting and ultraviolet steriliza-tion,yet its complex microscopic physical processes and discharge mechanisms remain incompletely understood.In this study,a plasma fluid model of the discharge tube is coupled with an external circuit.The discharge tube is modeled as a one-dimensional axial Ar-Hg plasma discharge driven by an AC power source.A self-consistent solu-tion is obtained for the external circuit behavior and the axial distributions of electron density,electron temperature,and collision frequency within the tube.The results indicate that during the initial discharge stage,the tube voltage continuously decreases while the discharge current increases slightly.After reaching steady state,particle densities are higher near both electrodes and become nearly uniform along the axial direction.Under a ballast resistance of 400 Ω,the electron density reaches 1.9×1018 m-3.A maximum electron density of 4.7×1018 m-3 is achieved at an argon partial pressure of 57 Torr.With increasing argon partial pressure,the electron temperature decreases from 8 240 K to 4 178 K,whereas the collision frequency increases from 0.5~11.8 GHz.These findings provide a theo-retical basis for optimizing electron density in Ar-Hg gas discharges.
年,卷(期):
2026, 45(9)
分类号:
O461.213
机标分类号:
O536
O461
TN322.8
在线出版日期:
2026年10月14日
基金项目:
52307190:国家自然科学基金IEERF250303:中国科学院电工研究所科研基金,