摘要
焊后热处理(PWHT)可以有效地减轻钢结构焊接接头中的残余应力(RS),然而现有研究通常关注焊后热处理的最终结果,缺少对热循环过程中应力演变的详细机制分析,特别是对于几何形状复杂的铸钢接头.针对这一问题,本研究以G20Mn5-Q355铸钢接头环向对接焊缝为研究对象,利用数值模拟方法,分析了焊后热处理过程中残余应力的演化规律.焊接过程包括5道电弧焊,焊后热处理参数按照相关规范确定.结果表明:焊后热处理可将轴向和环向残余应力峰值降低90%以上;应力松弛主要发生在加热阶段,占总减小量的近75%,由材料软化和蠕变效应驱动.对工艺参数的分析表明,残余应力的消减程度主要受焊后热处理温度的影响,而消减速率受加热速率的影响.以上结论明确了焊后热处理对残余应力的消减机制,并建议优先考虑升高热处理温度来提高效率,为相关工艺优化提供了参考.
Post-weld heat treatment(PWHT)is widely used to mitigate residual stresses(RSs)in welded steel struc-tures.However,existing studies have often reported PWHT outcomes without providing detailed mechanistic analyses of stress evolution during the thermal cycle,particularly for geometrically complex cast steel joints.To address this gap,this study investigated the G20Mn5-Q355 cast steel girth butt weld,employing a numerical simulation to dissect the RS evolution throughout the PWHT process.The model,validated against a five-pass arc welding procedure and code-compliant PWHT parameters,revealed that PWHT reduces peak axial and hoop RS by over 90%.The key innovative finding was that stress relaxation was highly stage-dependent—the heating stage alone accounted for nearly 75%of the total reduction,driven by material soften-ing and creep effects.Furthermore,parameter analysis dem-onstrated that the holding temperature predominantly con-trols the final extent of RS reduction,whereas the heating rate influences the rate of relaxation.These insights offer a fundamental understanding of the PWHT mechanism and provide guidance for optimizing industrial procedures by pri-oritizing heating stage parameters to enhance efficiency.