摘要
针对某型无人机吊舱环境控制系统的散热需求,开展配套液冷泵的设计与性能分析.基于冷却液65号工作介质,系统需满足进口压力为50 kPa、出口流量35 L/min、出口供液压不低于0.55 MPa的工况条件.采用速度系数法完成离心叶轮与蜗壳的关键尺寸设计,对泵体进行CFD仿真验证,对比了不同介质温度对泵性能的影响;并搭建测试平台,对液冷泵性能进行了测试.结果表明,在设计工况点,泵的扬程为55.98 m,效率为44.5%,功耗为1.04 kW;在低温条件下,介质粘度显著增大,导致泵的扬程下降,效率相应降低;液体泵实测性能指标与设计指标吻合较好.本文为环控系统的冷却性能评估以及吊舱系统设计工况运行策略提供依据.
This paper focuses on the heat dissipation requirements of the environmental control system of a certain type of UAV pod,and carries out the design and performance analysis the matching hydraulic pump.Based on the cooling medium 65,the system needs to meet the working conditions of inlet pressure 50 kPa,outlet flow 35 L/min,and outlet hydraulic pressure not less than 0.55 MPa.The key dimensions of the centrifugal impeller and volute are designed by the velocity coefficient,the pump body is simulated and verified by CFD,and the influence of different medium temperatures on the pump performance is com-pared,and a test platform was built to test the performance of the liquid cooling pump.The results show that,at the design condi-tion point,the pump head is 55.98 m,the efficiency is 44.5%,the power consumption is 1.04 kW,under the low temperature condition,the medium viscosity increases significantly,resulting in a decrease in the pump head and a corresponding decrease in efficiency.The measured performance indicators of the liquid pump match the design indicators well.This paper provides a basis for the cooling performance evaluation of the environmental control system and the operating strategy of the pod system design con-ditions.