Hole Excavation Rectification Technology for Tilting High Rise Buildings in Strongly Weathered Rock Base
摘要
高层建筑倾斜后的纠倾难度与风险显著高于一般建筑,强风化岩层岩掏孔响应显著区别于土层,亟待研究该类地层掏孔法纠倾的可行性与控制策略.以某下伏强风化花岗岩的倾斜高层建筑纠倾项目为依托,首先结合现场勘查与设计资料分析致倾原因;进而基于掏孔纠倾原理与地层损失理论,建立不同地层损失率的数值模型,模拟掏孔引发的地基变形发展与基础沉降规律,据此完善纠倾设计方案及突沉控制措施.研究表明:当地层损失率低于 80%时基础沉降平稳,超过 80%后塑性区贯通导致沉降速率剧增,通过基底分序掏孔施工并配合千斤顶止沉,建筑物南北向倾斜率由纠倾前的 4.63%成功回倾至 1.33%,满足规范限值要求.掏孔法通过合理设计与动态控制,可用于强风化花岗岩地基高层建筑的纠倾,施工过程应密切关注地基的地层损失率并预设防突沉措施.
The difficulty and risk of correcting the tilt of high-rise buildings are significantly higher than those of gener-al buildings.The response of rock cavities in weathered rock layers is significantly different from that in soil layers,making it urgent to analyze the feasibility and control strategies of correcting the tilt using the cavity method in such ge-ological formations.Based a tilt correction project of a high-rise building on highly weathered granite,the causes of tilting were first analyzed by combining field investigations and design data;then,based on the principles cavity tilt correction and ground loss theory,numerical models with different ground loss rates were established to simulate the development of ground deformation and foundation settlement caused by cavities,thereby improving the tilt correction scheme and sudden settlement control measures.The study shows that when the ground loss rate is below 80%,the foundation settlement is stable;when it exceeds 80%,the of the plastic zone leads to a sharp increase in the settlement rate.By implementing sequential cavity construction at the foundation base and using hydraulic jacks to stop the settle-ment,the north-south rate of the building was successfully corrected from 4.63%before correction to 1.33%,meeting the code limit requirements.Through reasonable design and dynamic control,cavity method can be applied to the tilt correction of high-rise buildings on highly weathered granite foundations.During the construction process,the ground loss rate of the foundation should be closely,and measures to prevent sudden settlement should be preset.