基于Aspen Plus工业锅炉甲醇部分裂解掺烧模拟研究
Simulation Study of Methanol Partial Cracking Blending in Industrial Boiler Based on Aspen Plus
摘要
针对甲醇热值低、汽化潜热高带来的问题,提出了工业锅炉甲醇部分裂解掺烧技术路径.基于Aspen Plus 软件模拟分析过量空气系数α和裂解比例β对燃烧和排放特性的影响.结果表明:甲醇直燃系统在α=1.01 时达到温度与热功率峰值,NOx 排放随α增加呈先升后降趋势;裂解掺烧系统通过调节β可显著提升燃烧强度,但需通过α与β的协同优化(最佳参数α=1.05、β=0.53)平衡燃烧性能与排放,在燃烧温度提升 220℃的同时,将 NOx 质量浓度控制在 50 mg/m3 以内;最终设计的裂解掺烧锅炉系统相比传统直燃系统热效率提升 1.6%,实现了燃烧强化与排放控制的协同优化,为甲醇清洁高效利用提供了新路径.
Aiming at the problems brought by the low calorific value and high latent heat of vaporization of methanol,a technological path for partial cracking and blending of methanol in industrial boilers is proposed.The effects of excess air coefficient(α)and cracking ratio(β)on combustion and emission characteristics were simulated and analyzed based on Aspen Plus software.The results show that the methanol direct combustion system reaches the peak temperature and thermal power atα=1.01 and the NOx emission tends to increase and then decrease with the increase ofα.The cracking blending system can significantly improve the combustion intensity by adjustingβ,but the synergistic optimization ofαandβ(with the best parameter ofα=1.05 andβ=0.53)is needed to balance the combustion performance and the emission,so that the combustion temperature is increased by 220℃while the NOx concentration is controlled within 50 mg/m3.The final design of the cracking-blending boiler system improves the thermal efficiency by 1.6%compared with the traditional direct-fired system,realizes the synergistic optimization of combustion intensification and emission control,and provides a new path for the clean and efficient utilization of methanol.
年,卷(期):
2026, 57(5)
分类号:
TK16
机标分类号:
TK421.5
TK229.6
C922
在线出版日期:
2026年10月23日
基金项目:
2021SX5:中国工程院院地合作项目,