摘要
针对45钢表面镍基SiC涂层激光熔覆工艺研发周期长、成本高、稳定性及成形质量差等问题,进行了工艺参数优化研究.以45钢为基体,Ni40-10%SiC复合粉末为熔覆材料,基于Box-Behnken响应曲面法设计15组单道激光熔覆试验,分析激光功率、扫描速度、送粉速率对稀释率与润湿角的影响规律.通过多元回归分析构建工艺参数与响应指标的预测模型,结合方差分析验证模型有效性,根据合意度函数完成多目标工艺参数优化.结果表明,稀释率主要受激光功率和送粉速率的影响,激光功率与稀释率大小呈正相关,送粉速率与稀释率负相关;扫描速度和送粉速率对涂层润湿角的影响最大,润湿角随送粉速率增大而升高、随扫描速度增大而减小.最优工艺参数为:激光功率1 530 W、扫描速度5 mm/s、送粉速率15.5 g/min,试验验证指标误差均低于10%.最优参数下涂层无宏观缺陷,截面组织分层均匀、元素分布无偏析,成形质量良好.结果证实该模型精度可靠,可为制备高质量、无缺陷激光熔覆涂层提供技术支撑.
To address issues such as prolonged development cycles,high costs,poor stability,and inferior forming quality in laser cladding of nickel-based SiC coatings on 45 steel,an optimization study of process parameters was conducted.Using 45 steel as the substrate and Ni40-10%SiC composite powder as the cladding material,15 single-pass laser cladding experiments were designed based on the Box-Behnken response surface methodology to investigate the influence of laser power,scanning speed,and powder feed rate on dilution rate and wetting angle.A predictive model was constructed for process parameters and response indicators through multiple regression analysis,the effectiveness of the model was validated through variance analysis,and multi-objective parameters were optimized based on the consensus function.Results indicate that dilution rate is primarily influenced by laser power and powder feed rate,with laser power positively correlated and powder feed rate negatively correlated with dilution rate.Scanning speed and powder feed rate exert the greatest impact on coating wetting angle,which increases with higher powder feed rates and decreases with faster scanning speeds.The optimized process parameters are that laser power was 1 530 W,scanning speed was 5 mm/s,and powder feed rate was 15.5 g/min,with experimental validation errors below 10%.Under optimal parameters,the coating has no macroscopic defects,uniform layering of cross-sectional structure,no segregation of element distribution,and good forming quality.Research results confirm that the accuracy of the model is reliable and can provide technical support for the preparation of high-quality,defect free laser cladding coatings.