Occurrence and embedding characteristics of micro-fine grained gold in a gold mine in Yunnan and its constraint mechanism on recovery
摘要
金矿石的高效开发利用对国家金融安全与经济稳定至关重要.本研究综合采用x射线荧光光谱(XRF)、x射线衍射分析(XRD)、扫描电子显微镜(SEM)及自动矿物分析仪(MLA)等手段,对某金矿开展了系统的工艺矿物学研究.结果表明,矿石中主要有价元素为金和银,品位分别为1.29 g·t-1和7.50 g·t-1,均具备综合回收价值;金属矿物以黄铁矿为主,非金属矿物主要为石英和白云母.金主要以裸露金形式产出,占有率达88.37%,硫化物包裹金占8.53%;金矿物以自然金为主(84.28%),其次为银金矿(11.07%)和碲金银矿(3.74%).金矿物粒度分布呈现两极分化特征,39.16%分布于40~60 μm,而37.23%小于5 μm;黄铁矿嵌布粒度较细,主要集中于0.02~0.104 mm.11.37%的金以包裹金形式赋存于黄铁矿中,且粒度均小于5μm,即使细磨亦难以充分解离,构成影响金回收率的关键矿物学瓶颈.针对这一特征,建议采用粗粒重选与细粒强化磨矿相结合的回收策略,尤其应关注对小于10 μm金矿物的定向回收.本研究为明确影响金回收的矿物学制约因素及制定合理选冶工艺提供了理论依据.
The efficient development and utilization of gold ores are crucial to national financial security and economic stability.In this study,a systematic process mineralogical investigation was carried out on a gold ore from Yunnan using X-ray fluorescence spectroscopy(XRF),X-ray diffraction analysis(XRD),scanning electron microscopy(SEM),and mineral liberation analyzer(MLA).The results show that the main valuable elements in the ore are gold and silver,with grades of 1.29 g·t-1and 7.50 g·t-1,respectively,both having comprehensive recovery value.The metallic minerals are dominated by pyrite,while the non-metallic minerals are mainly quartz and muscovite.Gold predominantly occurs as exposed gold,accounting for 88.37%,followed by sulfide-hosted gold(8.53%).The gold-bearing minerals are mainly native gold(84.28%),followed by electrum(11.07%)and petzite(3.74%).The particle size distribution of gold minerals exhibits a bipolar characteristic,with 39.16%in the 40-60μm range and 37.23%finer than 5 μm.Pyrite is relatively fine-grained,mainly concentrating in the 0.02-0.104 mm size fraction.A total of 11.37%of the gold occurs as inclusions in pyrite,all finer than 5 μm,which are difficult to fully liberate even after fine grinding,constituting a critical mineralogical constraint on gold recovery.To address this challenge,a combined recovery strategy of coarse-particle gravity separation and enhanced fine grinding is recommended,with particular attention to the targeted recovery of gold minerals finer than 10 μm.This study provides a theoretical basis for identifying the mineralogical factors constraining gold recovery and for developing rational beneficiation and metallurgical processes.