Study on co-slurrying and secondary gasification characteristics of high-carbon component from gasification fine slag and coal based on ultra fine grinding
摘要
气化细渣因副产量大、残炭高具有一定热值、富含孔隙结构难脱水等特征,导致资源化处置成本高,已成为制约煤气化行业可持续发展的难题.气化细渣掺混制备水煤浆,可协同水煤浆现有工艺,为其提供源头减量化、规模化与资源化的处置途径.为此,以气化细渣分选所得高碳组分和原煤为原料,开展气化细渣高碳组分与煤协同制备气化煤浆技术研究.在不影响煤浆性能前提下,系统分析了气化细渣高碳组分粒径对掺混量的影响规律,明确了最大掺混量对应的最佳粒径,并评估了其二次气化可行性.结果表明:在固定煤浆浓度、黏度及流动性条件下,气化细渣高碳组分粒径越小,对煤浆性能的影响越低.经超细研磨活化后,在模拟工业运行参数下,高碳组分最大掺混量由3%提升至15%,此时高碳组分微粒粒径<15 μm颗粒占比为71.12%(体积分数),D50约为8 μm;X-ray Nano-CT成像技术表征表明,超细研磨后的高碳组分颗粒在煤浆中同时发挥填充和包覆作用:填充于间隙的超细颗粒可提高煤浆堆积密度,包覆于粗煤粒表面则可形成聚集态结构,从而改善煤浆性能,降低其对煤浆性能的负面影响,最终实现掺混比例的提高;TG-DTG分析表明,气化细渣高碳组分的外推终止温度均低于1 350 ℃,在气化炉内具备完全反应的条件,经超细研磨活化后,提升了最大反应速率,降低了外推起始温度、外推终止温度和反应完全余量,表明残炭可在更短时间内完成气化反应.
Gasification fine slag poses a significant challenge to the sustainable development of the coal gasification industry due to its high by-product yield,high residual carbon content with caloric value,porous structure that impedes dewatering,and consequently high resource utilization costs.Incorporating this slag into coal water slurry(CWS)preparation offers a synergistic approach with existing CWS processes,providing a pathway for its source reduction,large-scale disposal,and resource recovery.This study investigated the co-slurrying technology of the high-carbon component(HCC)derived from gasification fine slag with raw coal for gasification slurry production,alongside an evaluation of its secondary gasification reactivity.Without compromising slurry performance,the influence of HCC particle size on its blending ratio was systematically analyzed to determine the optimal particle size and the maximum allowable blending ratio.Furthermore,the feasibility of secondary gasification was assessed.Results indicate that a smaller HCC particle size leads to a lesser negative impact on CWS performance at fixed concentration,viscosity,and fluidity.After ultra-fine grinding activation,under simulated industrial operating parameters,the maximum blending ratio increases from 3%to 15%.At this ratio,the HCC particles with size<15 pm account for 71.12%,with a D50 of approximately 8 pm.Characterization via X-ray Nano-CT reveals that the ultra-fine ground HCC particles serve a dual role within the slurry:filling interstitial voids to increase packing density,and coating the surfaces of coarse coal particles to form aggregated structures.This improves slurry performance,mitigates negative impacts,and ultimately enables a higher blending ratio.TG-DTG analysis shows that the extrapolated termination temperatures for HCC are all below 1 350℃,confirming that the conditions for complete reaction can be achieved within the gasifier.After ultra-fine grinding activation,the maximum reaction rate is increased,while the extrapolated onset and termination temperatures and the reaction completion margin are reduced,suggesting that the residual carbon can accomplish the gasification reaction in a shorter time.