Structural Design and Strength Characteristic Research on Key Components of a 300MW Turboexpander
摘要
针对高温环境工况下可调导叶的安全问题,对某 300MW 储能透平膨胀机第一级可调导叶及其执行机构进行了结构设计,在此基础上展开了有限元分析,对其设计工况下进行了数值模拟仿真,采用热固耦合的方法,对进气缸第一级可调导叶进行了热应力、接触应力以及驱动力的计算.结果表明:在设计工况下,除了局部强约束位置,可调导叶整体应力水平较低,均在 200MPa 以下,气缸最大等效应力为 78MPa,远低于材料的屈服极限,满足整体设计的强度要求,对可调导叶正常的运行产生的影响不大.该方法通过仿真可得到导叶部分的法向接触应力,为导叶驱动力的计算提供了理论依据.
Aiming at the safety issues of adjustable guide vanes under high-temperature operating conditions,structural design is carried out for the first-stage adjustable guide vanes and their actuators of a 300MW energy storage turbine expander.On this basis,finite element analysis is conducted,and numerical simulation is performed under the design condition.Using the thermo-solid coupling method,the thermal stress,contact stress and driving force of the first-stage adjustable guide vanes in the inlet cylinder are calculated.The results show that under the design condition,except for locally heavily constrained regions,the overall stress level of the adjustable guide vanes is relatively low and remains below 200MPa.The maximum equivalent stress of the cylinder reaches 78MPa,which is far lower than the yield limit of the material and meets the overall strength design requirements,exerting negligible influence on the normal operation of the adjustable guide vanes.This method can obtain the normal contact stress of the guide vane assembly via simulation,providing a theoretical basis for the calculation of the driving force of guide vanes.