轴系中心调整抑制汽流激振的试验研究
Experimental Study on Suppressing Steam Flow Induced Vibration by Shaft Center Adjustment
摘要
针对某汽轮机组频繁发生的振动突跳问题开展研究,试验发现高压转子内动静间隙不合理,产生了随负荷增大而增大的汽流激振力,汽流激振力超过一定阈值后激发出不稳定振动.阀序优化调整试验所取得的减振效果有限.提出基于轴系中心调整的解决方案,给出了调整前后振动、轴承温度、轴颈中心位置等数据.试验结果表明,轴系中心调整可以提高轴承稳定性,抑制汽流激振故障.1 号轴承位于端部,载荷对标高变化的灵敏度相对较低,标高调整量必须较大.为了减小轴承标高调整对汽缸内动静间隙的影响,可以采取 1 号轴承抬高和 2 号轴承降低的方法.研究结论可以指导汽流激振故障诊断和治理.
A study was conducted to address the frequent vibration-jump faults in a steam-turbine set.Tests revealed that the internal blade tip clearances in the high-pressure cylinder were unreasonable.A steam-flow excitation force that increases with load was generated.Once this force exceeded a certain threshold it triggered unstable vibrations.Valve-sequence optimization tests produced only limited vibration reduction effect.A remedy based on shaft-line centre adjustment is proposed.Data on vibration,bearing temperature and journal-centre position before and after the adjustment are presented.The results show that realigning the shaft line improves bearing stability and suppresses steam-flow-excited vibration.Bearing No.1 is at the end of the shaft line its load is comparatively insensitive to bearing elevation changes.The elevation adjustment of bearing No.1 must be large.To minimize the impact of bearing-elevation changes on the internal rotor-to-stator rub within the cylinder,Bearing No.1 can be raised while Bearing No.2 is lowered simultaneously.The conclusions provide guidance for diagnosing and eliminating steam-flow-excited vibration faults.
年,卷(期):
2026, 68(5)
分类号:
TK263.1
TH113.1
机标分类号:
TK227.1
TM311
TM614
在线出版日期:
2026年11月6日