军事知识服务平台
热输入对复杂内壁激光熔覆Stellite 6熔覆层组织及耐磨性能的影响
Effect of Heat Input on Microstructure and Wear Resistance of Stellite 6 Coating by Laser Cladding on Complex Inner Wall Surfaces
摘要 针对复杂内壁激光熔覆难题,以 22Cr12NiWMoV 钢为基体,采用 45°同轴激光头制备 Stellite 6 熔覆层,模拟内壁工况研究热输入影响.结果表明:45°同轴激光熔覆可实现稳定致密冶金结合.随着热输入的增加,组织由细晶向粗晶转变,裂纹敏感性增强;低热输入硬度最高,中等热输入组织均匀、成形最佳.物相均为 γ-Co 固溶体和 Cr 碳化物,热输入影响晶粒择优取向.中等热输入条件下组织均匀性最优、熔覆层成形质量最佳,磨损机制以磨粒磨损为主.热输入是调控组织与性能的关键,合理控制可提升内壁熔覆层质量,为工艺优化提供依据.
Abstract:
To address the challenges of uneven energy distribution and difficult forming in laser cladding on complex inner walls,Stellite 6 coatings were prepared on 22Cr12NiWMoV steel substrate using a 45° coaxial laser cladding head,and the effect of heat input was investigated under simulated inner-wall working conditions.The results show that the 45° coaxial cladding can achieve stable deposition with a dense metallurgical bond.With increasing heat input,the microstructure transitions from refined to coarser,and thermal accumulation and cracking susceptibility increase.The highest hardness is obtained at low heat input,while uniform microstructure and optimal forming are achieved at moderate heat input.The phases consistently consist of γ-Co solid solution and Cr carbides,but heat input influences grain growth and preferred orientation.The lowest wear rate and best wear resistance occur at moderate heat input,with abrasive wear as the dominant mechanism.Heat input is a key parameter for controlling microstructure and properties;proper control can improve the quality of cladding layers on complex inner walls,providing a basis for process optimization and wear-resistant coating design.
刊 名 汽轮机技术 ISTICPKU
年,卷(期): 2026, 68(5)
分类号: TG174.4 TG665
机标分类号: TG174.44 TG455 TB331
在线出版日期: 2026年11月6日
基金项目: 2025ZD1701200:煤炭重大专项,