A coupled system of compressed gas heating and water-based carbon capture for cold regions
摘要
[目的]为解决寒冷地区冬季供暖面临的高碳排放和清洁供暖需求间的矛盾,突破传统水基碳捕集法在常压下 CO2溶解度受限的技术瓶颈,本文提出了一种寒冷地区压缩气体供热与水基碳捕集耦合系统.[方法]系统集成了气体压缩、水基碳捕集和余热回收技术,利用寒冷地区天然冷能优势,降低气体压缩能耗的同时提升 CO2溶解能力,并回收压缩热用于供暖,实现碳捕集与清洁供暖的协同增效.基于热力学仿真建模,对系统的捕集性能、能耗特性及供热能力进行了多维度的量化分析.[结果]结果表明:在 10 MW 供热负荷工况下,系统的 CO2捕集能耗仅为290.18 kW·h/t,对应能耗成本为183.51元/t,较传统胺基化学吸收法降低约 25.43%;敏感性分析进一步表明,系统在较低环境温度、二级吸收压力≥1 200 kPa、二级循环水流量约 300~500 kg/s 以及入口 CO2 浓度≥15%的工况下运行性能更优.[结论]本研究提出的耦合系统通过压缩热梯级利用和两级碳捕集循环的协同设计,实现了高效碳捕集和稳定供暖,为寒冷地区实现清洁供暖与碳减排目标提供了一种新思路.
[Objective]To address the practical challenges in cold northern regions of China,including the growing demand for winter heating,severe pollution from coal combustion,and the performance degradation,efficiency drop and frost formation of air-source heat pumps under low-temperature conditions,this paper proposes a novel compressed gas heating and water-based carbon capture integrated system.[Methods]The system increases the pressure of flue gas through multi-stage compression,with the compression heat being utilized in a cascaded manner.The high-grade compression heat is used for residential heating,thereby avoiding the problem of frost formation in low-temperature environments with heat pump heating.Subsequently,the low-grade compression heat is harnessed to preheat the gas before it enters the expander within the expansion module,thus increasing the power output of the expander.In parallel,a two-stage water-based carbon absorption-desorption cycle is adopted to achieve CO2 enrichment and purification,harnessing the cold climate of northern regions to promote the dissolution of CO2 into the circulating water,while recovering a portion of the compression work via the expander.To evaluate the system's performance,a simulation model of the proposed system is constructed in Aspen Plus,with the specific energy consumption for CO2 capture,heating load,CO2 separation efficiency,and product gas purity designated as the key performance indicators.Based on these criteria,a quantitative performance analysis of the system is then carried out.A sensitivity study is conducted on key parameters such as ambient temperature and absorption pressure.[Results]Under the design condition of 10 MW heating supply,the system achieves a CO2 capture rate of 85.65%and a product gas purity of 99.72%.The specific energy consumption for CO2 capture is 290.18 kW·h/t and the capture cost amounts to 183.51 yuan/t,representing a reduction of about 25.43%compared with that of the conventional amine-based capture technology.Sensitivity analysis indicates that lower ambient temperature,higher second-stage absorption pressure(≥1 200 kPa),a moderate second-stage circulating water flow rate(300~500 kg/s),and a medium-to-high inlet CO2 concentration(≥15%)are conducive to achieving low-energy and high-efficiency operation of the system.[Conclusion]This study proposes an integrated system that combines compressed gas heating,low-temperature water-based carbon capture,and cascaded waste heat utilization,which enables the effective synergistic achievement of the dual goals of heating supply and carbon emission reduction.The system features the advantages of low capture energy consumption,stable heat supply,and strong environmental adaptability,providing a promising technical pathway for clean heating and low-carbon flue gas treatment in cold northern regions.