Comparative Study on Microstructure and Properties of V4-Series High-Speed Steel Manufactured by Electroslag Remelting,Powder Metallurgy and Spray Forming
摘要
以V4系高速钢为研究对象,分别经电渣重熔、粉末冶金和喷射成形三种不同工艺制备,系统对比工艺差异大尺寸模块显微组织及性能的影响,并综合分析喷射成形工艺的比较优势.实验结果表明,电渣重熔V4钢存在严重的碳化物偏析,呈现网状和带状分布,碳化物不均匀度达8级,大颗粒碳化物尺寸约为11.1~11.7 µm;粉末冶金V4钢组织最为均匀,碳化物不均匀度为0级,碳化物尺寸仅3.0 µm;喷射成形V4钢碳化物不均匀度为1级,碳化物尺寸为9.0 µm,组织均匀性显著优于电渣重熔钢.经相近热处理工艺处理后,三种钢硬度均达到62 HRC以上.其中,喷射成形V4钢硬度为62.8 HRC,略低于粉末冶金V4钢(63.8 HRC)和电渣重熔V4钢(63.6 HRC),但其耐磨性能最佳,磨损量仅为0.036 g.综上所述,喷射成形V4钢组织均匀性、耐磨性均接近粉末冶金V4钢,且成本相对来说更具优势,经此研究结果可为V4系高性能高速钢的制备工艺选择提供理论与实验的参考依据.
Taking V4 high-speed steel as the research subject,we employed three different processes—electroslag re-melting,powder metallurgy,and spray forming.The effects of process differences on the microstructure and proper-ties of large-sized modules were systematically compared,and the comparative advantages of the spray forming process were comprehensively analyzed.Experimental results showed that electroslag-remelted V4 steel exhibited severe car-bide segregation,presenting a network-like and banded distribution with a carbide inhomogeneity reaching grade 8 and large carbide particle sizes of approximately 11.1 µm to 11.7 µm;powder-metallurgy V4 steel exhibited the most uniform microstructure,with a carbide inhomogeneity of grade 0 and a carbide size of only 3.0 µm;spray-formed V4 steel exhibited a carbide inhomogeneity of grade 1 and a carbide size of 9.0 µm,with significantly better microstruc-ture uniformity than electroslag-remelted steel.After similar heat treatment processes,all three steels achieved hard-ness above 62 HRC.Among them,spray-formed V4 steel exhibited a hardness of 62.8 HRC,slightly lower than that of powder-metallurgy V4 steel(63.8 HRC)and electroslag-remelted V4 steel(63.6 HRC),but it exhibited the best wear resistance with a wear loss of only 0.036 g.In summary,spray-formed V4 steel demonstrated microstructure uni-formity and wear resistance comparable to powder-metallurgy V4 steel,while also offering relatively greater cost advan-tages.These findings provide theoretical and experimental references for the selection of preparation processes for V4 series high-performance high-speed steel.