The bending properties determine fabrics drape,garment shape,and comfort.However,the current cantilever method requires multiple samples cutting and repeated testing,which is time-consuming and produces inconclusive results.The research aims to develop a new method that can simultaneously obtain multiple sets of data in one test and visually display the bending differences of the fabrics and samples in various directions.Twenty-four woven fabrics with varying structures,fiber compositions,and bending properties were used as test subjects.A simple device consisting of an adjustable displacement platform,a CCD camera,and a scale was constructed.Four new parameters,namely,protruding length L,falling height H,projected area A,and bending index I,were measured.The bending length C and bending stiffness B were also measured using the cantilever method for comparison.Pearson correlation and regression fitting were used to verify the correspondence between the new parameters and traditional parameters.Finally,based on the cantilever beam small-deformation model,the explicit relationship between the bending stiffness and geometric quantities was derived,and the Bisshopp elliptic integral correction was introduced to construct a stiffness inversion process under large-deformation conditions.
The results show that the four new parameters,L,H,A and I were all significantly correlated with bending length C,and bending stiffness B at the 0.01 or 0.05 level.the R values of L and C were≥0.877(0°)and 0.926(90°)and H was quadratically negatively correlated(R2=0.795)with bending length C.Regression models were established:C=6.550L+11.855(R2=0.815);C=-5.285H2+35.079H-27.433(R2=0.795);C and I were polynomially related.Besides,stiffer fabrics had larger projection and smaller falling height,while the opposite was true for soft fabrics.The theoretical fabric-bending stiffness values obtained from the small-deflection model differed markedly from the experimental data.After applying the Bisshopp elliptic-integral correction,the discrepancy was sharply reduced,with most errors falling within±5%of the measured values.
The single test,multi-dimensional visualization method proposed in this article has good feasibility due to its simple device,low cost,adjustable parameters,and intuitive results.Besides,the stiffness-inversion workflow valid for large deflections established in this paper can enable an integrated bending morphology and mechanical rigidity identification as well as unify full-field visualization with quantitative stiffness determination.The approach can provide a theoretical framework for the rapid,visual and quantitative evaluation of fabric-bending performance.