Full-scale experimental study on electric vehicle fire characteristics in road tunnels
摘要
针对公路隧道新能源汽车火灾中动力电池持续热失控、复燃及毒性烟气控制困难的问题,依托全尺寸隧道试验平台,开展电池模组、电池包及新能源汽车整车多尺度火灾试验,并初步探究二氧化碳、水基、七氟丙烷、全氟己酮和灭火毯5种方式对动力电池热失控的控制效果.在此基础上,提出隧道自动覆盖隔离新技术和装置.试验结果表明,动力电池火灾强度除受电池容量影响外,还与热失控同步程度和封装状态密切相关;4个模组同步热失控时喷射距离超过1.5 m,完整电池包则表现出更明显的阶段性和持续性.整车火灾约300 s后进入快速发展阶段,约600 s形成全面燃烧,火源正上方拱顶最高温度达到271.39 ℃,距火源100 m处拱顶CO峰值达到290 ppm,且毒性烟气影响可持续至明火衰减以后.5种灭火方式均能快速抑制外部明火,但喷射式灭火方式停止作用后仍出现不同程度复燃;灭火毯覆盖后未见明火复燃,模组最高温度最大降幅达到75.6%,并表现出较好的持续隔离作用.通过缩尺试验,初步验证了自动覆盖隔离技术的可行性.
This study aims to investigate the fire characteristics and control challenges associated with new ener-gy vehicles in road tunnels,particularly sustained thermal runaway of traction batteries,reignition,and toxic smoke control.Full-scale tunnel fire tests were conducted at multiple scales,including battery modules,battery packs,and a full-scale new energy vehicle.The effectiveness of five suppression methods—carbon dioxide,a wa-ter-based agent,heptafluoropropane,perfluorohexanone,and a fire blanket—on controlling battery thermal run-away was also preliminarily investigated.Based on these tests,an automatic covering and isolation technology and device for tunnel fire control were proposed.The results show that battery fire severity is governed not only by battery capacity,but also by the degree of thermal-runaway synchronization and the enclosure condition.When four battery modules underwent thermal runaway simultaneously,the jet flame distance exceeded 1.5 m,whereas complete battery packs exhibited more pronounced staged and sustained burning characteristics.The full-scale ve-hicle fire entered a rapid development stage at approximately 300 s and became fully developed at approximately 600 s.The maximum ceiling temperature directly above the fire source reached 271.39 ℃,and the peak carbon monoxide(CO)concentration at the tunnel ceiling 100 m from the fire source reached 290 ppm.The effects of toxic smoke persisted even after visible flames had decayed.All five suppression methods rapidly suppressed ex-ternal flames;however,varying degrees of reignition occurred after the spray-based suppression methods were ter-minated.No visible flame reignition was observed after fire-blanket coverage,and the maximum reduction in bat-tery-module temperature reached 75.6%,indicating a sustained isolation effect.Scale-model tests further demon-strated the feasibility of the proposed automatic covering and isolation technology.