军事知识服务平台
Ce对Fe-Ni-Al-Mo系马氏体时效钢动态再结晶行为的影响
Effect of Ce on the Dynamic Recrystallization Behavior of Fe-Ni-Al-Mo Maraging Steels
摘要 热变形过程中的动态再结晶行为是研究合金显微组织和性能调控的重要依据.本文利用热模拟实验机以0.1 s-1的应变速率分别在900℃、1000℃、1100℃和1150℃下进行单道次热压缩实验,基于变形过程中的真应力应变曲线,结合显微组织表征,研究了 Ce对马氏体时效钢动态再结晶的影响.结果表明:热变形温度为900 ℃时,添加Ce前后Fe-Ni-Al-Mo系马氏体时效钢真应力应变曲线分别表现为动态再结晶和加工硬化;热变形温度为1000℃和1100 ℃时,添加Ce前后Fe-Ni-Al-Mo系马氏体时效钢真应力应变曲线均表现为加工硬化;在1150℃时则表现为动态再结晶.在热变形温度为900 ℃、1000 ℃、1100 ℃和1150 ℃的条件下,Ce分别提高了实验钢热变形过程中的峰值应力21.49 MPa、23.37 MPa、7.42 MPa和11.59 MPa.显微组织分析表明,热变形过程中稀土元素Ce延缓了 Fe-Ni-Al-Mo系马氏体时效钢动态再结晶的发生过程.热变形温度1150 ℃时,Fe-Ni-Al-Mo系马氏体时效钢平均晶粒尺寸从24.075 μm减小到21.385 μm,表明Ce细化了其动态再结晶晶粒.
Abstract:
The dynamic recrystallization behavior during thermal deformation is an important basis for the regulation of al-loy microstructure and properties.In this paper,for the thermal deformation process demand of maraging steel,the effect of rare earth Ce on dynamic recrystallization of maraging steel was investigated based on the true stress-strain curves in the de-formation process combined with the microstructure characterization by conducting single-pass hot compression experiments with a strain rate of 0.1 s-1 using thermal simulation experimental machine at 900 ℃,1000 ℃,1100 ℃ and 1150 ℃,re-spectively.The results show that the true stress-strain curves of Fe-Ni-Al-Mo maraging steels before and after the addition of Ce at the heat distortion temperature of 900 ℃ show work hardening and dynamic recrystallization,respectively.The true stress-strain curves of Fe-Ni-Al-Mo maraging steels before and after the addition of rare earth Ce at the heat distortion tempera-tures of 1000 ℃ and 1100 ℃ exhibit work hardening,while dynamic recrystallization is shown at 1150 ℃.The rare earth Ce increased the peak stresses during thermal deformation of the experimental steels by 21.49 MPa,23.37 MPa,7.42 MPa,and 11.59 MPa at the thermal deformation temperatures of 900 ℃,1000 ℃,1100 ℃,and 1150 ℃,respectively.Microstructure analysis shows that the rare earth element Ce retards the onset of dynamic recrystallization in Fe-Ni-Al-Mo maraging steels dur-ing thermal deformation.The average grain size of Fe-Ni-Al-Mo maraging steel decreased from 24.075 μm to 21.385 μm at the thermal deformation temperature of 1150 ℃,indicating that the rare earth Ce refined its dynamic recrystallized grains.
刊 名 稀土 ISTICPKU
年,卷(期): 2026, 47(4)
分类号: TG142.1
机标分类号: TG156.99 TQ323.5 TG316.8
在线出版日期: 2026年9月17日
基金项目: 51961030:国家自然科学基金52161008:国家自然科学基金2022ZY0072:中央引导地方科技发展资金项目,