Effect of anode slotting on the electric field and thermal field of rare earth electrolytic cells
摘要
针对中小型稀土电解槽电解效率低、底部金属凝结堆积以及高温导致阳极消耗等问题,本文以15 kA稀土电解槽为研究对象,通过对阳极在四个边缘部分进行开槽(开槽宽度为10 mm、20 mm、30 mm、40 mm),来改善电解的电场与温度场,并运用COMSOLMultiphysics进行数值模拟,考察开槽宽度对电解槽电场和热场分布的影响.研究表明,阳极开槽可显著优化槽内电-热场分布,开槽区域高温区温度明显下降,下降幅度在70 K左右,中心高温区面积缩减50%左右,阳极效应强度削弱,保障了两极间稀土金属主反应区的高效电解;当开槽宽度为20 mm时,电解槽电流密度达到峰值,槽温相比未开槽(1 500 K)显著下降28 K,阳极消耗关联高温区温度降幅达3.1%,电解效率达82.3%,各工况最优;20 mm开槽的最大电流密度略高于未开槽0.33×10⁴ A/m²,符合镨钕熔盐流动要求;20~30 mm开槽可明显改善热场均匀性,减少稀土金属底部堆积(凝结量降低约12%),延长槽体寿命至245天.综上,电解槽阳极开槽20 mm时,工况最佳,且能适配镨钕电解对电流密度与反应温度的需求,同时有效减少高温导致的阳极损耗并缓解底部金属熔盐堆积沉底问题,进而降低资源消耗、延长电解槽使用寿命,具备工业推广价值.
To address the problems of low electrolytic efficiency,metal condensation and accumulation at the cell bottom,and high-temperature-induced anode consumption in small-and medium-sized rare earth electrolytic cells,this study takes a 15 kA rare earth electrolytic cell as the research object.Slots with widths of 10 mm,20 mm,30 mm,and 40 mm were cut at the four edge sections of the anode to improve the electric field and temperature field during electrolysis.COMSOL Multiphysics was used to perform numerical simulations to investigate the influence of slot width on the distributions of the electric field and thermal field in the electrolytic cell.The results indicate that anode slotting can significantly optimize the electro-thermal field distribution within the cell:the temperature of the high-temperature zone in the slotted region drops markedly,with a decrease of approximately 70 K;the area of the central high-temperature zone is reduced by about 50%;and the intensity of the anode effect is weakened,thereby ensuring efficient electrolysis in the main reaction zone of rare earth metal between the two electrodes.When the slot width is 20 mm,the current density of the cell reaches its peak,and the cell temperature decreases significantly by 28 K compared with that of the unslotted cell(1 500 K);the temperature drop in the high-temperature zone associated with anode consumption reaches 3.1%,and the electrolytic efficiency reaches 82.3%,representing the optimal operating condition among all cases.The maximum current density at a slot width of 20 mm is slightly higher than that of the unslotted cell by 0.33×10⁴ A/m²,which satisfies the flow requirements of the Pr-Nd molten salt.Slot widths of 20-30 mm can markedly improve the uniformity of the thermal field,reduce the accumulation of rare earth metal at the cell bottom(with the condensation amount decreased by about 12%),and prolong the cell service life to 245 days.In conclusion,an anode slot width of 20 mm yields the optimal operating condition,which can adapt to the requirements of Pr-Nd electrolysis in terms of current density and reaction temperature,while effectively reducing anode loss caused by high temperature and alleviating the accumulation and settling of metal and molten salt at the cell bottom.Consequently,it lowers resource consumption and prolongs the service life of the electrolytic cell,demonstrating value for industrial application.