Removal of calcium from acid in-situ leaching solutions of uranium using cation exchange resin
摘要
铀矿作为核能发展的核心原料,在当今世界的能源供应和军事战略中扮演着极为关键的角色.酸法地浸采铀中经常会发生堵塞,造成产能下降.其主要原因是浸出液中钙离子过多生成硫酸钙沉淀导致.本研究采用一种新型钠型苯乙烯系大孔强酸性阳离子树脂Y2X8树脂去除Ca2+.实验表明在树脂用量50 mL/L、温度25℃、pH=7.5、转速175 r/min、吸附时间15 min的条件下,Y2X8型树脂对Ca2+去除率超过98%,最大吸附容量达34.5 mg/mL.实验结果表明,伪二级动力学模型(R2>0.996)和Langmuir等温线模型(R2>0.93)更适用于拟合吸附过程,表明Y2X8树脂对Ca2+的吸附为均质单分子层吸附,且以化学吸附为主导.竞争吸附实验表明,Y2X8树脂对Ca2+具有高选择性,分配系数显著高于共存离子,并表现出良好的宽pH适应性与抗共存离子干扰能力.表征分析表明,磺酸基团与Ca2+之间的离子交换和静电相互作用是吸附的关键机制.上述结果表明,Y2X8型磺酸树脂是一种高效去除浸出液中Ca2+的树脂材料,为解决酸法地浸采铀中由于硫酸钙沉淀造成的钻孔堵塞和矿层渗透性下降问题提供了一种新的思路.
Uranium ore,as the core raw material for nuclear energy development,plays a crucial role in today's world energy supply and military strategy.In acid in-situ leaching of uranium,clogging often occurs,leading to reduced production capacity,mainly due to excessive calcium ions in the leachate.This study investigated the removal of calcium using a novel sodium-type macroporous strongly acidic styrene-based cation exchange resin,Y2X8.Experiments showed that under the conditions of resin dosage 50 mL/L,temperature 25℃,pH=7.5,stirring speed 175 r/min,and adsorption time of 15 min,the removal rate of Ca2+by Y2X8 resin exceeded 98%with a maximum adsorption capacity of 34.5 mg/mL.The results indicated that the pseudo-second-order kinetic model((R2>0.996)and the Langmuir isotherm model(R2>0.93)were more suitable for fitting the adsorption process,suggesting that the adsorption of Ca2+by Y2X8 resin is homogeneous monolayer adsorption dominated by chemisorption.Competitive adsorption experiments showed that Y2X8 resin exhibited high selectivity toward Ca2+,with a distribution coefficient significantly higher than those of coexisting ions,along with good adaptability over a wide pH range and resistance to interference from coexisting ions.Characterization analysis revealed that ion exchange and electrostatic interactions between sulfonic acid groups and Ca2+are the key mechanisms of adsorption.These results demonstrate that Y2X8 sulfonic resin is an efficient material for removing Ca2+from wastewater,providing a new approach to addressing borehole clogging and reduced formation permeability caused by calcium sulfate precipitation in acid in-situ leaching of uranium.