Laser-regulated oxygen-doped molybdenum disulfide for SERS detection of procalcitonin
摘要
[目的]研究激光热效应调控氧掺杂二硫化钼(oxygen-doped molybdenum disulfide,O-MoS2),用于降钙素原(procal-citonin,PCT)的特异性表面增强拉曼散射(surface-enhanced Raman scattering,SERS)检测方法.[方法]采用激光粗化钼片在表面形成三氧化钼(molybdenum trioxide,MoO3),经高温气相硫化转化为二硫化钼(molybdenum disulfide,MoS2),通过改变激光的欠焦距离,利用激光的热效应对MoS2进行O掺杂的方法制备O-MoS2;调控激光参数实现基底微观形貌、晶格结构调控从而实现SERS增强,以罗丹明6G(rhodamine 6G,R6G)为探针分子评价O-MoS2的SERS性能并对PCT进行检测.[结果]O-MoS2基底用于PCT的SERS检测具有稳定性和特异性,对PCT的检测限为0.45 μg·mL-1.[结论]激光热效应法可实现O原子在MoS2 中的均匀掺杂,O掺杂能显著增强MoS2的SERS性能,O-MoS2基底检测具有较好的稳定性与特异性,为非贵金属SERS基底制备提供新路径,可用于细菌感染相关生物标志物检测.
Objective To address the issues of high cost and poor stability of noble metal surface-enhanced Raman scattering(SERS)sub-strates,as well as insufficient active sites and low charge transfer efficiency of pure MoS2,the laser thermal effect is used to achieve controllable oxygen doping of MoS2,to prepare a highly uniform O-MoS2 SERS substrate,and to establish a specific SERS detection method for the bacterial infection biomarker procalcitonin(PCT).
Methods High-purity molybdenum sheets were used as raw materials and etched by a 1 064 nm pulsed laser in air to form MoO3.Using 10 vol%H2S as the sulfur source,the MoO3 was sulfurized at high temperature to obtain pure-phase MoS2.Oxygen doping of MoS2 was carried out in air using defocused laser irradiation to obtain O-MoS2.The phase,morphology,crystal struc-ture,surface chemical state,and SERS performance of the materials were characterized and tested using XRD,SEM,HRTEM,XPS,and laser confocal Raman spectroscopy.Using rhodamine 6G(R6G)as the SERS probe molecule,the laser power and number of laser irradiation cycles for oxygen doping were optimized,and the O-MoS2 with optimal SERS performance was used for PCT detection.
Results and Discussion When the laser defocus distance was 6 cm,the temperature on the MoS2 surface was 324 ℃,which sat-isfied the conditions required for oxygen doping.Oxygen doping did not destroy the crystal structure of MoS2 but only caused slight lattice distortion,which was beneficial for ion transport and provided more active sites.The optimal SERS performance of the O-MoS2 substrate was achieved at a laser power of 3%and one irradiation cycle,under which the oxygen doping amount on the material surface was the highest.The Raman signal of O-MoS2 was about 10 times higher than that of MoS2.Characteristic peaks were still observed at an R6G concentration of 10-7 mol·L,and the relative standard deviations of the characteristic peak signals at 10 test sites were all<5%,indicating excellent detection repeatability and stability.When applied to PCT detection,the characteristic peak intensity of PCT showed a good linear relationship with the concentration in the range of 1-30 mg·L-1.The linear equation was y=2 425.04+559.50x,R2=0.977 01,and the limit of detection was 0.45 mg·L-1.Specificity experi-ments showed that IL-6 and CRP caused almost no interference,indicating that the O-MoS2 substrate exhibited specificity for PCT detection.
Conclusion 1)To address the issues of poor doping uniformity and uncontrolled distribution of oxygen active sites in conven-tional O-MoS2 preparation methods,a strategy based on the laser thermal effect is proposed for site-specific oxygen doping regu-lation of the MoS2 substrate,which enables uniform doping of O atoms in the MoS2 substrate.2)The O-MoS2 substrate prepared by laser-thermal-effect regulation exhibits excellent SERS performance and surface stability.Using R6G as the probe molecule,the lower limit of signal response reaches 10-7 mol·L,and the relative standard deviations of the characteristic peaks at 10 test sites on the same substrate are all less than 5%,demonstrating good detection repeatability and stability.3)When applied to PCT detection,it shows a good linear relationship between concentration and Raman signal intensity in the target concentration range of 1~30 mg·L-1,with a detection limit of 0.45 mg·L-1.This study provides a high-performance substrate material and a preparation method for the SERS detection of biomarkers.